the locating bushings are the compact version of the AP20;
the locating bushings are the counterpart from the swivel (AP49);
* in the technical drawing means l = 1.5: marking line;
D in the table stands for the nominal diameter;
F(kN) in the table stands for the maximum load capacity;
d in the table stands for the locating hole;
there are two versions available that can be mounted into wood (type 1 and 3), a version that can be mounted into plastic (type 2) and two versions with a holding (type 4 and 5);
both bushings in type 1, 2 and 4 allow an interlock of 4x90°;
the bushing in type 3 and 5 enables a 360° rotation in the locked state;
temperature range from minimum -50°C to maximum 150°C.
Assembly:
mounting in wood (type 1 and 3);
1) insert location hole and pilot hole for safety bolt according to specifications;
2) optionally recommended is the use of adhesive for securing;
3) press in bushing;
4) secure bushing with a screw;
note: the bore diameter (D2) for the pilot hole of the safety bolt depends on the screw used.
mounting in plastic (type 2);
1) insert location hole according specifications;
2) optionally recommended is the use of adhesive for securing;
3) screw in bushing;
note: the bore diameter to be chosen for the location hole depends on the hardness of the plastic.