the eccentric clamp allows clamping with "pull-down" effect on different work piece forms at low height;
L8 in the technical drawing represents the height of the workpiece;
M (Nm) in the table represents the maximum tightening torque;
F1 (kN) in the table represents the clamping force.
Assembly:
1) manufacture a thread with the corresponding distance L3 / L4 to the work piece;
2) screw in the eccentric clamp at the necessary height and set it relative to the work piece with its flat side;
3) insert the work piece and tighten the clamping pin using the internal hexagon ( 1/3 turn);
the threaded hole must be lubricated on a regular basis; the rotational movement during tightening must always be completed towards the stops in order to prevent the work piece from turning away from the stops.