body: steel, case hardened, nitrided, phosphate treated (manganese), ground;
clamping jaw: steel, case hardened, nitrided, phosphate treated (manganese).
Characteristics:
floating clamps with separate clamping and locking are used to clamp and support additional clamping points on extremely pliable workpieces;
clamping and supporting force can individually be designated;
clamps ribs, beads and shackles to reinforce clamped components;
distortion-free clamping of raw parts;
the thread bore must always be closed for safe functioning;
for specific clamping situations, the standard clamping jaws supplied can be exchanged or replaced (see technical drawing: screw ISO 4762 - M8 - 12.9, M max. = 43 Nm);
additional flexible possibility of fitting with holder HE16.0306.0350 or holding plate for down-hold clamps HE09.1229.1200;
clamping jaws with an increased clamping range, see HE36, are available.
Assembly:
1) mount the floating clamp (M 12 connection thread) onto the device with a wrench (SW);
2) adjust the height limit stop and the rotating area with the blue sleeve and clamp with a set screw (3x SW1). When setting the height limit.
Operation:
1) push the floating clamp downward; 2) pivot the clamping jaws in; 3) release floating clamp; the bottom jaw contacts the work piece with a low spring force; 4) tighten the fixture nut (WS 18) having a maximum torque of 15 Nm; 5) thereafter tighten the hexagon collar nut (WS 10) as far as possible (max. torque 10 Nm); 6) the clamping process is finished; 7) releasing is done in reverse order: release hexagon collar nut (WS 10) - release fixture nut (WS 18) - pivot the clamping jaws out; 8) Floating clamp is in end position.
