clamping jaw: case hardened steel, nitrided, phosphate treated (manganese).
Characteristics:
type 1: lower standard clamping jaw, can be used with the HE72.0006.0000, HE73.0006.0000, HE35.0006.0000 and HE35.0106.0000;
type 2: upper standard clamping jaw, can be used with the HE72.0006.0000, HE73.0006.0000, HE35.0006.0000 and HE35.0106.0000;
type 3: upper exchange clamping jaw, can be used with the HE72.0006.0000, HE35.0006.0000 and HE35.0106.0000;
type 4: upper clamping jaw with location hole, can be used with the HE72.0006.0000, HE35.0006.0000 and HE35.0106.0000;
type 5: upper clamping jaw with flat-faced ball and pivot function, plain surface, protected against rotation, can be used with the HE72.0006.0000, HE35.0006.0000 and HE35.0106.0000;
* in the dimensional drawing indicates that the dimensions and material type of self-manufactured clamping jaws must be observed;
* 1: standard clamping jaw;
* 2: top switch jaw;
type 3: can be used to increase the clamping range;
type 4: if desired, various standard parts can be screwed in, internal thread M 8;
type 5: adapts to the draft of the workpiece;
x in the table indicates for which system the jaw is suitable;
x1 in the table represents the clamping range (mm).
Assembly:
When using custom-made jaws, it is important to insert the tightening screw (M8-12,9, 43 Nm) 10 mm deep into the clamp housing on the upper clamping jaw and 9 mm deep into the clamp housing on the lower clamping jaw.